Side and Bottom Mounting Lab Frame

Description

This mounting option is recommended for situations when you need a lab support lattice to cover the entire back panel of your fume hood. The horizontal rods of this Lab-Frame should measure 1/4” less than the interior width of your hood.
Assembly Instructions:
Lattice frame: Use the connectors and lattice rods to assemble the frame. The kit assumes a lattice spacing of 1-foot; however, this may vary depending on your application. Rods may be cut to fit as necessary.
Mounting: Attach vertical base plates to the horizontal and vertical rod ends. Base plates may be secured with
#10 screws
.
Mounting Screws Not Included.
NOTE:
Follow your fume hood manufacturers’ requirements for attachment.
4 foot Kit Includes:
(3)
1/2″ X 36″ Rods
(2)
1/2″ X 38″ Rods
(6)
Connectors
(7)
Vertical Base Plates
(1)
Assembly Instructions
6 foot Kit Includes:
(5)
1/2″ X 36″ Rods
(2)
1/2″ X 62″ Rods
(10)
Connectors
(9)
Vertical Base Plates
(1)
Assembly Instructions
8 foot Kit Includes:
(7)
1/2″ X 36″ Rods
(2)
1/2″ X 86″ Rods
(14)
Connectors
(11)
Vertical Base Plates
(1)
Assembly Instructions